Matt Shirley b0b950b7e1 config: Add Wanhao Duplicator 9 MK1 (#2497) ...

Also applies to the Monoprice Maker Pro MK1.
This config is based on the version from Chris Barnes (https://www.facebook.com/Jarannis)
found on https://pastebin.com/raw/wm8PQezy. This config was mostly working and I
only had to change a few things:

  - updated key names for min_point and max_point to mesh_min and mesh_max
  - enabled PID control
  - tweaked bounds to allow movement during mesh leveling
  - removed all comments
  - decreased homing speed slightly
  - sane bed mesh sample defaults

In response to Kevin O'Connor:

- remove pressure_advance setting from extruder section
- remove respond section
- remove pause_resume section

Signed-off-by: Matt Shirley <mdshw5@gmail.com>

2020-02-13 20:52:31 -05:00

1.8 KiB

Raw Blame History

View Raw