Deploying to gh-pages from @ Klipper3d/klipper@272e815522 🚀

Config_Reference.html

@@ -6914,6 +6914,10 @@ pin:
 #   A list of G-Code commands to execute when the button is released.
 #   G-Code templates are supported. The default is to not run any
 #   commands on a button release.
+#debounce_delay:
+#   A period of time in seconds to debounce events prior to running the
+#   button gcode. If the button is pressed and released during this
+#   delay, the entire button press is ignored. Default is 0.
 </code></pre></div>
 
 <h3 id="output_pin">[output_pin]<a class="headerlink" href="#output_pin" title="Permanent link">&para;</a></h3>
@@ -8178,6 +8182,11 @@ more information.</p>
 #   dispatch and execution of the runout_gcode. It may be useful to
 #   increase this delay if OctoPrint exhibits strange pause behavior.
 #   Default is 0.5 seconds.
+#debounce_delay:
+#   A period of time in seconds to debounce events prior to running the
+#   switch gcode. The switch must he held in a single state for at least
+#   this long to activate. If the switch is toggled on/off during this delay,
+#   the event is ignored. Default is 0.
 #switch_pin:
 #   The pin on which the switch is connected. This parameter must be
 #   provided.