Deploying to gh-pages from @ Klipper3d/klipper@6af931c4e1 🚀

zh/Measuring_Resonances.html

@@ -1687,7 +1687,7 @@ To avoid too much smoothing with '3hump_ei', suggested max_accel <= 3
 Recommended shaper is 3hump_ei @ 72.6 Hz
 </code></pre></div>
 
-<p>If you compare to the previously suggested parameters, the vibrations are a bit larger, but the smoothing is significantly smaller than previously, allowing larger maximum acceleration.</p>
+<p>新的参数与之前的建议比，振动要大一些，但平滑度明显比之前小，允许打印时更高的极限加速度。</p>
 <p>When deciding which <code>max_smoothing</code> parameter to choose, you can use a trial-and-error approach. Try a few different values and see which results you get. Note that the actual smoothing produced by the input shaper depends, primarily, on the lowest resonance frequency of the printer: the higher the frequency of the lowest resonance - the smaller the smoothing. Therefore, if you request the script to find a configuration of the input shaper with the unrealistically small smoothing, it will be at the expense of increased ringing at the lowest resonance frequencies (which are, typically, also more prominently visible in prints). So, always double-check the projected remaining vibrations reported by the script and make sure they are not too high.</p>
 <p>Note that if you chose a good <code>max_smoothing</code> value for both of your axes, you can store it in the <code>printer.cfg</code> as</p>
 <div class="highlight"><pre><span></span><code>[resonance_tester]