sht3x: Add sht31 support (#6560)

Signed-off-by: Timofey Titovets <nefelim4ag@gmail.com>

docs/Config_Reference.md

@@ -2575,6 +2575,25 @@ sensor_type:
 #   Interval in seconds between readings. Default is 30
 ```
 
+### SHT3X sensor
+
+SHT3X family two wire interface (I2C) environmental sensor. These sensors
+have a range of -55~125 C, so are usable for e.g. chamber temperature
+monitoring. They can also function as simple fan/heater controllers.
+
+```
+sensor_type: SHT3X
+#i2c_address:
+#   Default is 68 (0x44).
+#i2c_mcu:
+#i2c_bus:
+#i2c_software_scl_pin:
+#i2c_software_sda_pin:
+#i2c_speed:
+#   See the "common I2C settings" section for a description of the
+#   above parameters.
+```
+
 ### LM75 temperature sensor
 
 LM75/LM75A two wire (I2C) connected temperature sensors. These sensors

docs/Status_Reference.md

@@ -445,6 +445,7 @@ The following information is available in
 
 [bme280 config_section_name](Config_Reference.md#bmp280bme280bme680-temperature-sensor),
 [htu21d config_section_name](Config_Reference.md#htu21d-sensor),
+[sht3x config_section_name](Config_Reference.md#sht31-sensor),
 [lm75 config_section_name](Config_Reference.md#lm75-temperature-sensor),
 [temperature_host config_section_name](Config_Reference.md#host-temperature-sensor)
 and
@@ -452,7 +453,7 @@ and
 objects:
 - `temperature`: The last read temperature from the sensor.
 - `humidity`, `pressure`, `gas`: The last read values from the sensor
-  (only on bme280, htu21d, and lm75 sensors).
+  (only on bme280, htu21d, sht3x and lm75 sensors).
 
 ## temperature_fan