h3n3/klipper
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity

filament_switch_sensor: update documentation

Browse Source 
Signed-off-by:  Eric Callahan <arksine.code@gmail.com>
This commit is contained in:
Arksine
2019-02-09 19:40:03 -05:00
committed by KevinOConnor
parent 3c79e484d5
commit 69491e2dab
2 changed files with 29 additions and 0 deletions
Download Patch File Download Diff File Expand all files Collapse all files

21
config/example-extras.cfg
View File

@@ -1368,3 +1368,24 @@
#recover_velocity: 50.
# When capture/restore is enabled, the speed at which to return to
# the captured position (in mm/s). Default is 50.0 mm/s.
# Filament Switch Sensor. Support for filament insert and runout detection
# using a switch sensor, such as an endstop switch.
#[filament_switch_sensor my_sensor]
#pause_on_runout: True
# When set to True, a PAUSE will execute immediately after a runout is
# detected. Note that if pause_on_runout is False and the runout_gcode is
# omitted then runout detection is disabled. Default is True.
#runout_gcode:
# The gcode to run after a filament runout is detected. If pause_on_runout
# is set to True this gcode will run after the PAUSE is complete. The default
# is not to run any gcode commands.
#insert_gcode:
# The gcode to run after a filament insert is detected. The default is not to
# run any gcode commands, which disables insert detection.
#event_delay: 3.0
# The minimum amount of time in seconds to delay between events. Events
# triggered during this time period will be silently ignored. The default
# is 3 seconds.
#switch_pin:
# The pin on which the switch is connected. This parameter must be provided.