tmc: Configurable multistep_filt

Signed-off-by: Alex Voinea <voinea.dragos.alexandru@gmail.com>

docs/Config_Changes.md

@@ -20,6 +20,9 @@ parameters if `[input_shaper]` was enabled already.
 20230407: The `stalled_bytes` counter in the log and in the
 `printer.mcu.last_stats` field has been renamed to `upcoming_bytes`.
 
+20230323: On tmc5160 drivers `multistep_filt` is now enabled by default. Set
+`driver_MULTISTEP_FILT: False` in the tmc5160 config for the previous behavior.
+
 20230304: The `SET_TMC_CURRENT` command now properly adjusts the globalscaler
 register for drivers that have it. This removes a limitation where on tmc5160,
 the currents could not be raised higher with `SET_TMC_CURRENT` than the

docs/Config_Reference.md

@@ -3202,6 +3202,7 @@ run_current:
 #   set, "stealthChop" mode will be enabled if the stepper motor
 #   velocity is below this value. The default is 0, which disables
 #   "stealthChop" mode.
+#driver_MULTISTEP_FILT: True
 #driver_IHOLDDELAY: 8
 #driver_TPOWERDOWN: 20
 #driver_TBL: 2
@@ -3243,6 +3244,7 @@ run_current:
 #   The address of the TMC2209 chip for UART messages (an integer
 #   between 0 and 3). This is typically used when multiple TMC2209
 #   chips are connected to the same UART pin. The default is zero.
+#driver_MULTISTEP_FILT: True
 #driver_IHOLDDELAY: 8
 #driver_TPOWERDOWN: 20
 #driver_TBL: 2
@@ -3417,6 +3419,7 @@ run_current:
 #   to tune a motor with unbalanced coils. See the `Sine Wave Lookup Table`
 #   section in the datasheet for information about this field and how to tune
 #   it.
+#driver_MULTISTEP_FILT: True
 #driver_IHOLDDELAY: 6
 #driver_IRUNDELAY: 4
 #driver_TPOWERDOWN: 10
@@ -3532,6 +3535,7 @@ run_current:
 #   values used by the driver. The value must be specified as a decimal integer
 #   (hex form is not supported). In order to compute the wave table fields,
 #   see the tmc2130 "Calculation Sheet" from the Trinamic website.
+#driver_MULTISTEP_FILT: True
 #driver_IHOLDDELAY: 6
 #driver_TPOWERDOWN: 10
 #driver_TBL: 2