Deploying to gh-pages from @ Klipper3d/klipper@fa78e6b8fb 🚀

zh-Hant/RPi_microcontroller.html

@@ -1398,8 +1398,8 @@
 <p>如果你想把主機作為一個輔助MCU，klipper_mcu程序必須在klippy程序之前執行。</p>
 <p>安裝 Klipper 后，執行以下命令來安裝指令碼：</p>
 <div class="highlight"><pre><span></span><code>cd ~/klipper/
-sudo cp &quot;./scripts/klipper-mcu-start.sh&quot; /etc/init.d/klipper_mcu
-sudo update-rc.d klipper_mcu defaults
+sudo cp ./scripts/klipper-mcu.service /etc/systemd/system/
+sudo systemctl enable klipper-mcu.service
 </code></pre></div>
 
 <h2 id="_1">構建微控制器程式碼<a class="headerlink" href="#_1" title="Permanent link">&para;</a></h2>