Deploying to gh-pages from @ Klipper3d/klipper@ddf0994ba2 🚀

Config_Changes.html

@@ -1195,6 +1195,20 @@
   
   
   
+    <li class="md-nav__item">
+      <a href="CANBUS_Troubleshooting.html" class="md-nav__link">
+        CANBUS Troubleshooting
+      </a>
+    </li>
+  
+
+            
+          
+            
+              
+  
+  
+  
     <li class="md-nav__item">
       <a href="TSL1401CL_Filament_Width_Sensor.html" class="md-nav__link">
         TSL1401CL filament width sensor
@@ -1295,6 +1309,11 @@ are not backwards compatible. It is a good idea to review this
 document when upgrading the Klipper software.</p>
 <p>All dates in this document are approximate.</p>
 <h2 id="changes">Changes<a class="headerlink" href="#changes" title="Permanent link">&para;</a></h2>
+<p>20230530: The default canbus frequency in "make menuconfig" is
+now 1000000. If using canbus and using canbus with some other
+frequency is required, then be sure to select "Enable extra low-level
+configuration options" and specify the desired "CAN bus speed" in
+"make menuconfig" when compiling and flashing the micro-controller.</p>
 <p>20230525: <code>SHAPER_CALIBRATE</code> command immediately applies input shaper
 parameters if <code>[input_shaper]</code> was enabled already.</p>
 <p>20230407: The <code>stalled_bytes</code> counter in the log and in the