Deploying to gh-pages from @ Klipper3d/klipper@b7c243db19 🚀

CANBUS.html

@@ -1607,6 +1607,16 @@ interface.</p>
 </li>
 </ul>
 <ul>
+<li>It is only valid to use USB to CAN bridge mode if there is a
+  functioning CAN bus with at least one other node available (in
+  addition to the bridge node itself). Use a standard USB
+  configuration if the goal is to communicate only with the single USB
+  device. Using USB to CAN bridge mode without a fully functioning CAN
+  bus (including terminating resistors and an additional node) may
+  result in sporadic errors even when communicating with the bridge
+  node.</li>
+</ul>
+<ul>
 <li>A USB to CAN bridge board will not appear as a USB serial device, it
   will not show up when running <code>ls /dev/serial/by-id</code>, and it can not
   be configured in Klipper's printer.cfg file with a <code>serial:</code>