diff --git a/640.md b/640.md
index 5fffbd4..089748c 100644
--- a/640.md
+++ b/640.md
@@ -188,6 +188,12 @@ Once you have your RC receiver connected to the board and bound (linked) to yur
 
 ![640 RC receiver](/images/rc640.png)
 
+## 640 Pinout
+
+The pins used by the 640 board are shown in the diagram below. All GND pins are linked so have all been marked.
+
+![640 Pinout](/images/640pinout.png)
+
 # Programming the 640
 
 ## Installing the Python libraries
diff --git a/escape.md b/escape.md
index badf48f..0545d82 100644
--- a/escape.md
+++ b/escape.md
@@ -201,10 +201,16 @@ The RC receiver is connected to the 3-pin connector on the far left of the board
 
 Once you have your RC receiver connected to the board and bound (linked) to yur RC transmitter, you should run the C++ PPM decoder example code ([below](#programming-the-escape-installing-the-c-libraries)) to make sure that the signals are being received correctly.
 
-![EScape RC receiver](/images/rcescape.png)
+![ESCAPE RC receiver](/images/rcescape.png)
 
 ## Advanced setup
 
+## ESCAPE Pinout
+
+The pins used by the ESCAPE board are shown in the diagram below. All GND pins are linked so have all been marked.
+
+![ESCAPE Pinout](/images/escapepinout.png)
+
 # Programming the ESCAPE
 
 ## Installing the Python libraries
diff --git a/images/640pinout.png b/images/640pinout.png
new file mode 100644
index 0000000..3e38ba1
Binary files /dev/null and b/images/640pinout.png differ
diff --git a/images/escapepinout.png b/images/escapepinout.png
new file mode 100644
index 0000000..dea22e1
Binary files /dev/null and b/images/escapepinout.png differ