Connector met haak er aan vast

KennedyPegboard/multiconnect/connectorWithClamp.py

@@ -0,0 +1,60 @@
+from ocp_vscode import *
+from build123d import *
+set_port(3939)
+
+# Kennedy Pegboard hole width = 10 x 10 mm
+# Hart to hart distance holes = 1-1/2" = 38.1 mm
+
+tt = thickness_toolboard = 2.0
+wc = width_connector = 20.0
+tb = thickness_bevel = 2.5
+teub = thickness_edge_until_board = 0.5
+ttc = thickness_total_connector = 4.0
+cw = clamp_width = 9.8
+tc = thickness_clamp = 4.0
+cbw = clamp_board_width = cw*2/3
+dcr = depth_clamp_room = 1.8 # Made it a bit deeper so the securing pin stays beneath the surface
+lcr = length_clamp_room = cw*0.25+2.4
+wch = width_clamp_hole = cw/3
+lch = length_clamp_hole = cw+0.2
+
+# Make the connector
+with BuildPart() as connector:
+    with BuildSketch() as connector_sk:
+        Circle(wc/2)
+    extrude(amount = ttc-teub)
+    # Generate a bevel
+    chamfer(connector.edges().group_by(Axis.Z)[-1], length = tb, length2 = tb)
+    # Extrude the last part of the connector
+    extrude(connector.faces().sort_by(Axis.Z)[-1], amount = teub)
+    # Make a hole for the security pin
+    with BuildSketch(connector.faces().sort_by(Axis.Z)[0]):
+        with Locations((cbw/2, 0)):
+            RectangleRounded(wch, lch, .5)
+    extrude(amount = -ttc, mode=Mode.SUBTRACT)
+    with BuildSketch(connector.faces().sort_by(Axis.Z)[0]):
+        RectangleRounded(lcr+1, lch, .5)
+    extrude(amount = -dcr, mode=Mode.SUBTRACT)
+
+# Build the clamp on the backside
+with BuildPart() as clamp:
+    with BuildSketch(connector.faces().sort_by(Axis.Z)[-1]) as sk_clamp:
+        with Locations((-cbw/6, 0)):
+            RectangleRounded(cbw, cw, .5)
+    extrude(amount = tt)
+    with BuildSketch(clamp.faces().sort_by(Axis.Z)[-1]) as sk_behindBoard:
+        with Locations((-cbw/4, 0)):
+            Rectangle(cw, cw)
+    extrude(amount = tc)
+    chamfer(clamp.edges().group_by(Axis.X)[0].sort_by(Axis.Z)[0], length = tc/5, length2 = cw-cbw-.01)
+    fillet(clamp.edges(Select.LAST).filter_by(Axis.Y)[0], .5)
+    fillet(clamp.edges().filter_by(Axis.Z), .5)
+    fillet(clamp.edges().filter_by(Axis.X)[0], .5)
+
+# Put the two parts together
+with BuildPart() as kbMulticonnector:
+    add(connector)
+    add(clamp)
+
+export_stl(kbMulticonnector.part, "connectorWithClamp.stl")
+show(kbMulticonnector)